×

You are using an outdated browser Internet Explorer. It does not support some functions of the site.

Recommend that you install one of the following browsers: Firefox, Opera or Chrome.

Contacts:

+7 961 270-60-01
ivdon3@bk.ru

  • Influence of a heat source from ignition on the calculated combustion curve of polyethylene foam in a fire in a compartment

    This article analyzes the calculated fire curve in accordance with the ignition heat source in the compartment. To predict the calculated fire curve, the exponential equation proposed in the previous study was compared with the heat release rate measured in a fire experiment. The lag index, which is the main factor used to predict the time it will take to reach the maximum heat release rate, has decreased in proportion to the ignition heat source.

    Keywords: fire calculation curve, pipe insulation, ignition heat source, deceleration index, heat release rate

  • Numerical analysis of heat transfer in a multi-pipe configuration for various mixtures of liquids

    In this article, we investigate the effectiveness of using multiple pipes for heat dissipation. The study assumes laminar flow under steady-state conditions. Various mixtures are numerically investigated at different flow rates. Various nanofluids flowing through multiple parallel pipes have been numerically investigated to study the effects of temperature rise. Thanks to the benefits they bring to the cooling process, nanofluids have opened up a new way to improve the performance of thermal systems. A typical nanofluid consists of a base fluid, which is usually water, and nanoparticles.

    Keywords: heat exchanger, flow tube, nanofluid, bottom heating, coefficient of friction, pressure drop

  • Investigation of heat and mass transfer processes in gas filters

    Solid particles (PM) contaminate the filter surfaces and enter the pores, as well as settle on the surfaces of catalysts and deactivate them. Therefore, this article discusses the filter system and the cleaning system. The paper describes the requirements for what they should contain and provide, what properties and parameters the filter material should have, as well as catalytic converters that contribute to an increased level of cleaning. It is also shown that the system that filters exhaust gases must be resistant to vibrations of up to 150 Hz at an acceleration of up to 4 g. The filter system and cleaning system must be equipped with devices that ensure the regeneration of catalysts at the site of dismantling. The purification system must ensure that the emissions of the following harmful substances are reduced.

    Keywords: solid particle, filter system, purification system, catalytic Converter, oxide, external environment, diesel engine

  • Influence of temperature and heat exchange processes of the external environment on the operation of the engine neutralize

    In modern conditions, internal combustion engines (ice) are the most popular power plant for a number of transport vehicles: cars, tractors, locomotives, river and sea transport vessels. Strict requirements of modern Euro-standards to the degree of "smokiness" of exhaust gases of diesel internal combustion engines and their toxicity contribute to the emergence of a dead end situation. It is almost impossible, using obvious technical solutions, to comply with the requirements of Euro-5 and Euro-6 standards while maintaining the acceptable growth in economic costs, internal combustion engines (ice) emit a significant amount of exhaust gases into the atmosphere, which is an environmental threat. The article considers the method of SHS technology and its advantages.

    Keywords: environmental threat, internal combustion engines, SHS technology, waste, synthesis, filters