×

You are using an outdated browser Internet Explorer. It does not support some functions of the site.

Recommend that you install one of the following browsers: Firefox, Opera or Chrome.

Contacts:

+7 961 270-60-01
ivdon3@bk.ru

  • Inductive properties of conducting cylinder with rotational electric field’s azimuth strength

    The analytical method for calculation of induction and inductive properties of conducting cylinder with azimuth density of rotational current has been proposed. The method permits: to calculate radial distributions of azimuth component for strength vector of rotational electric field, densities of whirling currents, specific heat rating, being emitted at the local area of conductor; to determine the dependence of average electro moving force (EMF) in the ring, inductive current and integral ohmic resistor from equivalent cavity’s radius of cylinder; on the base of energy considerations to calculate the inductance, being introduced by conducting cylinder. This calculation is executed for investigated electromagnetic fields, where the finite phase shift between the current and the flux exists. 
    Estimations, executed for real conductors and semiconductors, point out to that the great values of inductance can be achieved at the low frequencies for materials with a small specific resistance. The small values of inductance can be achieved at the very high frequency (VHF) and extremely high frequency (EHF) for materials with a large specific resistance.  

    Keywords: introduced inductance, induction, rotational electric field, alternating current, magnetic field flux

  • Multichannel OpAmp and JFET follower IC on radiation hardened array

    The features of circuit engineering and results of chip computer simulation which consists of 4-channel operational amplifier (op amp) and 2-channel electrometric voltage follower, designed for pre-processing of sensors signals in high-energy physics are considered. 
    The characteristic properties of designed op amp are the absence of current source in the input differential stage and the use of parallel high-frequency channel for increasing of the bandwidth and slew rate.
    The results of experimental research that have confirmed the low sensitivity of the parameters of designed integrated circuits created on the field programmable gate array "FGPA-1.3" without the horizontal p-n-p transistors to the influence of gamma-irradiation and electrons with energy of 4 MeV are given.  

    Keywords: operational amplifier, field programmable gate array, voltage follower, sensor, sensing element, radiation resistance.

  • Methods of measurement of small inductors for radio systems on a chip

    Technique for measurement of inductances (L) about 1 nanohenry or less one, is discussed. Two measurements of inductance L are executed. First one is executed for stub length l0, another - for stub length, shortened into N times. Formula for calculation of unknown inductance’ error has been obtained, where determination of unknown L with error closed to meter error has been succeeded by choice of parameters. It is shown that required measurement’s error of initial stub length for N=2 and N=5 is in tens micrometers’ range. Techniques for error’s diminishing have been considered. Estimation for basic stub length of 6,6 mm and 8,3 mm for N=2 and N=5 respectively has been executed. 

    Keywords: inductance, least-squares procedure, meter error, stub base

  • High-frequency bandpass RC filter on current repeaters

      This paper presents a generalized framework level band pass filter used in the construction of broadband active RC filters. The conditions that determine the potential stability of the broadband link and its parameters. A variant of circuit implementation, in which low parametric sensitivity of Q to passive circuit elements is achieved on the basis of its own compensate small-signal parameters of bipolar transistors parameters amplification. The results of computer simulations have confirmed that the principle of self compensate coupling semiconductor can significantly reduce the sensitivity of the parametric parts of the second-order band-pass filters based on existing low technologies.

    Keywords: system-on-chip, band pass filter, quality, current amplifier, the sensitivity, bipolar transistor

  • Private and mutual compensation circuits in symmetric stages CMOS operational amplifiers

      The paper discusses the features of their own circuits and mutual compensation circuitry in a differential stage in CMOS transistors. It is shown that their composition can significantly increase the differential gain in symmetric cascades with a dynamic load, significantly reduce common mode gain and extend the range of operating frequencies. As an example, the evolution of the basic concept of a symmetric stage and the results of its simulation in Cadence Virtuoso.

    Keywords: micro circuitry, structural synthesis, complex-function blocks, a differential stage, a CMOS transistor, system-on-chip

  • Abstracts

    `

    Keywords: